SparkFun Qwiic pHAT Extension for Raspberry Pi 400
8,50 €
Informami quando l'articolo è disponibile.
- Description
- Additional information
- Features
- Documents
Description
The SparkFun Qwiic pHAT Extension for the Raspberry Pi 400 provides you with a quick and easy solution to access all of the 400's GPIO, stack your favorite HAT right-side up, or connect a Qwiic-enabled device to the I2C bus (GND, 3.3V, SDA, and SCL). Since the Qwiic system allows for daisy-chaining boards with different addresses, you can also stack as many sensors as you’d like to the mounting holes on the pHAT to create a tower of sensing power!
The Qwiic pHAT Extension connects to the Raspberry Pi 400's GPIO using a 2×20 right angle header and extends out to the edge of the PCB. Two Qwiic connectors are included on each side of the board for easy access to the I2C bus. A set of large silicone bumpers have also been included for better stability when connecting the Qwiic pHAT Extension to the Raspberry Pi 400's GPIO port.
Note: The Raspberry Pi 400 is NOT included. Check the Hookup Accessories section below for Raspberry Pi 400 options.
Includes:
1x Qwiic pHAT Extension for Raspberry Pi 400
4x Tall Silicone Bumpers
Get Started with the SparkFun Qwiic pHAT Extension Guide
Additional information
| BRAND | Sparkfun |
|---|---|
| Produttore | Melopero Electronics |
| MPN | DEV-17512-A4 |
- 2x Qwiic Connection Ports
- 10x Mounting Holes
- Reroutes and extends a Raspberry Pi 400’s 40-pin headers to a vertical position
